Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T00:29:45.523Z Has data issue: false hasContentIssue false

A new high-strength spinodal alloy

Published online by Cambridge University Press:  01 April 2005

James A. Hanna*
Affiliation:
Thayer School of Engineering, Dartmouth College, Hanover, New Hampshire 03755
Ian Baker
Affiliation:
Thayer School of Engineering, Dartmouth College, Hanover, New Hampshire 03755
Markus W. Wittmann
Affiliation:
Thayer School of Engineering, Dartmouth College, Hanover, New Hampshire 03755
Paul R. Munroe
Affiliation:
Electron Microscope Unit, University of New South Wales, Sydney, NSW 2052, Australia
*
a) Address all correspondence to this author. e-mail: James.A.Hanna@Dartmouth.edu
Get access

Abstract

Preliminary investigations of a new high-strength alloy of composition Fe30Ni20Mn25Al25 (at.%) are described in this paper. The as-cast alloy consisted of a periodic two-phase microstructure of interconnected, ∼50-nm-wide rods with fully coherent {100} interfaces, strongly suggestive of formation by a B2 to [(B2 + body-centered cubic (bcc)] spinodal decomposition. The (Ni,Al)-rich B2 and (Fe,Mn)-rich bcc phases differed in lattice parameter by <0.5%. Hardness and yield strength of the as-cast alloy were found to be approximately 500 VPN and 1500 MPa, respectively, and increased by more than 50% after annealing at 550 °C for several days. (Fe,Mn)-rich precipitates with a β–Mn structure were observed in the annealed material.

Information

Type
Rapid Communication
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable