Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T00:05:35.148Z Has data issue: false hasContentIssue false

Oxide thin films for nanometer scale electron beam lithography

Published online by Cambridge University Press:  31 January 2011

J.L. Hollenbeck
Affiliation:
Ceramics Division, Department of Materials Science and Engineering, University of Illinois, Urbana, Illinois 61801
R.C. Buchanan
Affiliation:
Ceramics Division, Department of Materials Science and Engineering, University of Illinois, Urbana, Illinois 61801
Get access

Abstract

The exposure response of high resolution oxide resist materials has been examined under high intensity irradiation conditions (∼1 ⊠ 105 A/cm2) to determine the relationships among film characteristics, exposure requirements, and ultimate resolution, and to explore further the processes responsible for ablative exposure. Amorphous films of Al2O3, Y2O3, Sc2O3, 3Al2O3·2SiO2, and MgO·Al2O3 were deposited by rf sputtering onto substrates cooled to –196°C and found to require an exposure dose of approximately 5 ⊠ 103 C/cm2 to complete exposure. Amorphous film structure was found to be necessary to achieve rapid removal of material during exposure. Material properties also found to influence irradiation response and help guide the selection of new materials included ionic character, heat of formation, and melting point. Film thickness was found to influence strongly both exposure requirements and resolution, an optimum thickness occurring at approximately 90 nm in amorphous Al2O3. The dose requirement in 90 nm thick amorphous Al2O3 was determined to be 2.5 ⊠ 103 C/cm2, which is two to three orders of magnitude lower than that of oxide films produced by other techniques. Resolution of the rf sputtered oxide films allowed the production of 5.0 nm holes on 8.1 nm centers. A dedicated STEM was used for exposure studies as well as imaging, microdiffraction analysis, and monitoring of the transmitted beam current, and allowed a qualitative model of the exposure process in rf sputtered oxide resists to be developed.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable