Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T12:59:18.232Z Has data issue: false hasContentIssue false

Porous reaction-sintered AlN tapes for high-performance microelectronics application

Published online by Cambridge University Press:  31 January 2011

F. Y. C. Boey
Affiliation:
Nanyang Technological University, School of Materials Engineering, Nanyang Avenue, Singapore 639798, Singapore
A. I. Y. Tok
Affiliation:
Nanyang Technological University, School of Materials Engineering, Nanyang Avenue, Singapore 639798, Singapore
W. J. Clegg
Affiliation:
University of Cambridge, Department of Materials Science & Metallurgy, New Museums Site, Pembroke Street, Cambridge CB2 3QZ, United Kingdom
Get access

Abstract

A novel approach was undertaken in producing porous AlN microelectronics tapes with high thermal conductivity and low dielectric constant. This method involved polymer microspherical powders used as a sacrificial mold to introduce controlled porosity into the green tapes during pyrolysis. The Al2O3-rich porous green tapes were then reaction sintered at 1680 °C for 12 h to create porous AlN tapes. This work builds upon a previously developed novel reaction sintering process that densified and converted Al2O3-rich tapes (Al2O3–20 wt% AlN–5 wt% Y2O3) to AlN tapes at a relatively low sintering temperature of 1680 °C. The sintering behavior of the porous tapes was investigated, and the effects of the microsphere particle size and volume addition were studied. The microspheres successfully contributed to the significant reduction of tape density by porosity, and this contributed to lowering its dielectric constant. Dielectric constants of the AlN tapes were reduced to about 6.8 to 7.7 while thermal conductivity values were reasonable at about 46 to 60 W/mK. Coefficient of thermal expansion (CTE) values showed a linear trend according to phase composition, with the porous AlN tapes exhibiting CTE values of 4.4 × 10−6 to 4.8 × 10−6/°C, showing good CTE compatibility with silicon at 4.0 × 10−6/°C. The added porosity did not significantly affect the CTE values.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable