Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T01:50:10.383Z Has data issue: false hasContentIssue false

Sintering of Cordierite–borosilicate Glass Composites

Published online by Cambridge University Press:  31 January 2011

Jiin-Jyh Shyu
Affiliation:
Department of Materials Engineering, Tatung University, Taipei 104, Taiwan, Republic of China
Jui-Kai Wang
Affiliation:
Department of Materials Engineering, Tatung University, Taipei 104, Taiwan, Republic of China
Get access

Abstract

The sintering and properties of cordierite–borosilicate glass composites were investigated. For the composites with ≥35% low-viscosity glass, the sintered densities decreased with the increasing sintering temperature above 850 °C. No crystallization of the glass was found. For the composites with 50–90 wt% high-viscosity glass, the sintered densities remained nearly constant (>95%) in a wide sintering temperature range. However, cristobalite crystallized from the glass phase, resulting in an undesirably high coefficient of thermal expansion. Presintering processing and a lower heating rate improved the densification of the composites with low-viscosity glass while limiting that of the composites with high-viscosity glass. This result is explained by the difference in crystallizability between these two glasses. As low- and high-viscosity glass powders were simultaneously added, the density reduction was reduced and the coefficient of thermal expansion was closer to that of Si because of the absence of cristobalite phase. The dielectric constant of all the composites was in the typical range of 4.9–5.7 at 1 MHz.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable