Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T18:32:01.666Z Has data issue: false hasContentIssue false

Structural characterization and thermal stability of W/Si multilayers

Published online by Cambridge University Press:  03 March 2011

M. Brunel
Affiliation:
Laboratory of Crystallography, CNRS, 38042 Grenoble, France
S. Enzo
Affiliation:
Department of Physical Chemistry, DD 2137, 30123 Venice, Italy
M. Jergel
Affiliation:
Institute of Physics, Slovak Academy of Science, 842 28, Bratislava, Slovakia
S. Luby
Affiliation:
Institute of Physics, Slovak Academy of Science, 842 28, Bratislava, Slovakia
E. Majkova
Affiliation:
Institute of Physics, Slovak Academy of Science, 842 28, Bratislava, Slovakia
I. Vavra
Affiliation:
Institute of Electrical Engineering, Slovak Academy of Science, 842 39, Bratislava, Slovakia
Get access

Abstract

Tungsten/silicon multilayers with tungsten layers of a thickness of 1–2 nm were prepared by means of electron beam deposition. Their structure and thermal stability under rapid thermal annealing were investigated by a combination of x-ray diffraction techniques and cross-sectional transmission electron microscopy. The crystallization behavior was found to depend on the interdiffusion and mixing at the tungsten/silicon interfaces during deposition as well as during annealing. The as-deposited tungsten/silicon multilayers were amorphous and remained stable after annealing at 250 °C/40 s. Interdiffusion and crystallization occurred after annealing all samples from 500 °C/40 s up to 1000 °C/20 s. By performing the same heat treatment in the tungsten/silicon multilayers, the formation of body-centered cubic W was observed with a layer thickness ratio δW/δsi = 1, whereas tetragonal WSi2 was detected in tungsten/silicon multilayers with a layer thickness ratio of δw/δsi ∼0.25. This dependence of the crystallization products on the layer thickness ratio δw/δsi originates from the different phenomena of interdiffusion and mixing at the tungsten/silicon interfaces. The possible formation of bcc tungsten as a first stage of crystallization of tungsten-silicon amorphous phase, rich in tungsten, is discussed.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable