Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T23:47:25.359Z Has data issue: false hasContentIssue false

Synthesis behavior and grain morphology in mullite ceramics with precursor pH and sintering temperature

Published online by Cambridge University Press:  31 January 2011

Jae-Won Kim
Affiliation:
Department of Ceramic Science and Engineering, Changwon National University, Changwon, Kyungnam 641–773, Korea
Jae-Ean Lee
Affiliation:
Department of Ceramic Science and Engineering, Changwon National University, Changwon, Kyungnam 641–773, Korea
Yeon-Gil Jung*
Affiliation:
Department of Ceramic Science and Engineering, Changwon National University, Changwon, Kyungnam 641–773, Korea
Chang-Yong Jo
Affiliation:
High Temperature Materials Group, Korea Institute of Machinery and Materials, Changwon, Kyungnam 641–010, Korea
Jae-Ho Lee
Affiliation:
Department of Ceramic Engineering, Hanyang University, Seoul 133–791, Korea
Ungyu Paik
Affiliation:
Department of Ceramic Engineering, Hanyang University, Seoul 133–791, Korea
Get access

Abstract

The effects of the precursor pH and sintering temperature on the synthesizing behavior and morphology of mullite were studied using a stoichiometric mullite (3Al2O3 · 2SiO2) precursor sol. The mullite precursor sol was prepared by the dissolution of aluminum nitrate enneahydrate [Al(NO3)3 · 9H2O] into the mixture of silica sol. The precursor pH of the sols was controlled to the acidic (pH ≈ 1.5 to 2), intermediate (pH ≈ 4.5 to 5) and basic (pH ≈ 8.5 to 9) conditions. The gels dried from the synthesized aluminosilicate sols were formed into a disk shape under 20 MPa pressure; then the green bodies were sintered for 3 h in the temperature range of 1100–1600 °C. The synthesizing temperature of mullite phase was found to be above 1200 °C for pH ≈ 1.5 to 2, and above 1300 °C for pH ≈ 4.5 to 5 and pH ≈ 8.5 to 9. The grain morphology of the synthesized mullite was changed to a rod shape for pH ≈ 1.5 to 2, and granulate shape for pH ≈ 4.5 to 5 and pH ≈ 8.5 to 9 with increasing sintering temperature. It was found that the morphology of mullite particle was predominantly governed by precursor pH and sintering temperature. However, at higher pH, the precursor pH and sintering temperature did not affect the synthesis behavior and grain morphology.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable