Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T16:24:48.088Z Has data issue: false hasContentIssue false

Transmission electron microscopy microstructural characterization of Ti–Si–C–N coatings

Published online by Cambridge University Press:  31 January 2011

Yan Guo
Affiliation:
International Surface Engineering Research & Development Centre, Xi’an Jiaotong University, China
Shengli Ma
Affiliation:
International Surface Engineering Research & Development Centre, Xi’an Jiaotong University, China
Kewei Xu
Affiliation:
International Surface Engineering Research & Development Centre, Xi’an Jiaotong University, China
Tom Bell
Affiliation:
International Surface Engineering Research & Development Centre, Xi’an Jiaotong University, China; and Department of Metallurgy and Materials, The University of Birmingham, Birmingham B15 2TT, United Kingdom
Xiaoying Li
Affiliation:
Department of Metallurgy and Materials, The University of Birmingham, Birmingham B15 2TT, United Kingdom
Hanshan Dong*
Affiliation:
Department of Metallurgy and Materials, The University of Birmingham, Birmingham B15 2TT, United Kingdom
*
a)Address correspondence to this author. e-mail: h.dong.20@bham.ac.uk
Get access

Abstract

A new type of Ti–Si–C–N coatings deposited on high-speed steel substrate by means of pulsed direct current (dc) plasma-enhanced chemical vapor deposition was investigated. The as-deposited coatings were characterized systematically by using energy-dispersive x-ray spectroscopy, x-ray diffraction (XRD), transmission electron microscopy (TEM), and microhardness with particular attention paid to the microstructure of the coatings. It has been shown that C content has a profound effect on the microstructure and hardness of coatings. TEM and XRD analyses revealed that these coatings consist of the dominate Ti(C, N) with a silicide (TiSi2, Si3N4, or SiC, depending on the C content in the coatings). The crystallite sizes are in the range of 8–35 nm, which decrease with increasing C content. The Ti–Si–C–N coatings with high C content (25.2–38.6 at.%) possess superhardness (41–48 GPa). This can be attributed to the grain refinement/grain boundary hardening and dispersion hardening of the hard, nanosized crystalline Si3N4 or SiC formed in the deposition.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable