Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T08:53:56.728Z Has data issue: false hasContentIssue false

Alkali-resistant oxynitride glasses

Published online by Cambridge University Press:  31 January 2011

T.M. Holmes
Affiliation:
Department of Mechanical Engineering, Worcester Polytechnic Institute, Worcester, Massachusetts 01609
G.L. Leatherman
Affiliation:
Department of Mechanical Engineering, Worcester Polytechnic Institute, Worcester, Massachusetts 01609
T. El-Korchi
Affiliation:
Department of Civil Engineering, Worcester Polytechnic Institute, Worcester, Massachusetts 01609
Get access

Abstract

Oxynitride glasses in the Si–Zr–Na–Li–K–B–O–N system have been produced via incorporation of Si3N4 into the glass structure. This system is the oxynitride analogue of commercially available alkali resistant (AR) glasses used for concrete reinforcement. Glasses with nitrogen contents up to approximately 4 at.% have been obtained. Hardness, fracture toughness, and chemical durability were found to increase with increasing nitrogen content. Fibers were drawn from the glasses containing approximately 4 at.% nitrogen and used to produce reinforced cement composites. The microstructure of the fiber-matrix interface was examined in these samples after aging and compared to that of oxide AR glass fiber-matrix interface. Measurement of the wetting behavior of aqueous solution as a function of the nitrogen content of the glass suggests that this difference in microstructure is the result of changes in physiochemical properties of the glass surface due to the incorporation of nitrogen into the glass structure.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable