Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T09:13:40.133Z Has data issue: false hasContentIssue false

Aluminum metallization for flat-panel displays using ion-beam-assisted physical vapor deposition

Published online by Cambridge University Press:  31 January 2011

Zhenqiang Ma
Affiliation:
Department of Nuclear Engineering and Radiological Sciences, The University of Michigan, Ann Arbor, Michigan, 48109
Gary S. Was
Affiliation:
Department of Nuclear Engineering and Radiological Sciences, The University of Michigan, Ann Arbor, Michigan, 48109
Get access

Abstract

Failures in aluminum interconnects in display control devices are often caused by the formation of hillocks during postdeposition annealing. Ion-beam-assisted deposition was used to create a (110) out-of-plane texture in aluminum films to suppress hillocking. X-ray diffraction was used to quantify the (110)/(111) out-of-plane texture ratio, and scanning electron microscopy and atomic force microscopy were used to characterize the surface topology. Results show that no hillocks were observed on (110)-textured aluminum films following annealing for 30 min at 450 °C. Following annealing, the resistivity of the films made by ion-beam-assisted deposition recovered to within a factor of 2 of the physical-vapor-deposition films. Results show that ion-beam-assisted deposition can effectiv09ely modify the aluminum out-of-plane texture in such a way that hillock suppression can be achieved without significant change in resistivity.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable