Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T06:16:13.416Z Has data issue: false hasContentIssue false

Analysis of extended dislocation faults

Published online by Cambridge University Press:  31 January 2011

Arun M. Kumar
Affiliation:
Department of Mechanical and Materials Engineering, Washington State University, Pullman, Washington 99164-2920
John P. Hirth
Affiliation:
Department of Mechanical and Materials Engineering, Washington State University, Pullman, Washington 99164-2920
Get access

Abstract

The relative stability of standard extended dislocation dipoles and some new stable defects with lozenge-shaped cross sections have been numerically estimated. An earlier study of these defects in an isotropic fee structure has been extended to the anisotropic case to assess the effect of anisotropy on the calculations. The study is further extended to the case of the L12 crystal structure of the ordered alloy Ni3Al, where the Burgers vectors are large. Results indicate that the introduction of anisotropy has a small effect in determining the relative stability of extended dislocation faults. The results also show that the large values of the Burgers vectors stabilize the arrays in Ni3Al and that the most stable defect favored is the screw lozenge array LD.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable