Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T13:40:40.379Z Has data issue: false hasContentIssue false

Aqueous processing of SiC green sheets II: Binder and plasticizer

Published online by Cambridge University Press:  31 January 2011

J. X. Zhang
Affiliation:
The State Key Laboratory of High Performance Ceramics and Superfine Structure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, 1295 Dingxi Road, 200050 Shanghai, P. R. China
D. L. Jianga*
Affiliation:
The State Key Laboratory of High Performance Ceramics and Superfine Structure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, 1295 Dingxi Road, 200050 Shanghai, P. R. China
S.H. Tan
Affiliation:
The State Key Laboratory of High Performance Ceramics and Superfine Structure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, 1295 Dingxi Road, 200050 Shanghai, P. R. China
L. H. Gui
Affiliation:
The State Key Laboratory of High Performance Ceramics and Superfine Structure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, 1295 Dingxi Road, 200050 Shanghai, P. R. China
M. L. Ruan
Affiliation:
The State Key Laboratory of High Performance Ceramics and Superfine Structure, Shanghai Institute of Ceramics, Chinese Academy of Sciences, 1295 Dingxi Road, 200050 Shanghai, P. R. China
*
a)Address all correspondence to this author.
Get access

Abstract

Well-dispersed SiC slurries in the presence of binder and plasticizer were prepared and investigated in this series of work. In this part, poly(vinyl alcohol) (PVA) 1788 was investigated as a potential binder for aqueous tape casting process. The minimum amount of binder was determined through a primary calculation. Effects of the binder on SiC slurries properties were analyzed in term of zeta potential measurement and rheological test. Coupled with PEI as dispersant and glycerol as plasticizer, they lead to homogeneous systems which seem compatible. The suspensions (formulated with 47.9 wt% SiC powder, 1 wt% dispersant, 3.5 wt% binder, and 3.5 wt% plasticizer) exhibited a shear-thinning behavior with a very limited time-dependent character. After tape casting and drying process, the properties of green tapes were evaluated in term of solid content and gap height. The optimal solid content of SiC was found to be near 22.25 vol%, and the gap height, near 200 μm. The microstructure of green tape was characterized by TEM. Results showed that preparation of homogeneous green tapes with relative densities at about 51 vol% was feasible.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable