Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T18:14:46.194Z Has data issue: false hasContentIssue false

CeO2 insulating films for application to high-temperature superconducting digital devices

Published online by Cambridge University Press:  01 January 2006

Ai Kamitani*
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan
H. Wakana
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan
A. Ogawa
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan
S. Adachi
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan
K. Higuchi
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan; and Nihon University, Funabashi-city, Chiba 274-8501, Japan
H. Yamamoto
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan; and Nihon University, Funabashi-city, Chiba 274-8501, Japan
K. Tanabe
Affiliation:
Superconductivity Research Laboratory-International Superconductivity Technology Center (SRL-ISTEC), Koto-ku, Tokyo 135-0062, Japan
*
a)Address all correspondence to this author. e-mail: ai.kamitani@isen.iemn.univ-lille1.fr
Get access

Abstract

CeO2 thin films as insulating layers for high-temperature superconducting digital devices were studied. The dependence on substrate temperature and oxygen pressure of the surface morphology and crystallinity of CeO2 thin films prepared by pulsed laser deposition were investigated. CeO2 thin films with a flat and closely grained surface were obtained at a relatively low oxygen pressure of 3.6 Pa, whereas higher oxygen pressure led to CeO2 thin films with a rough surface and columnar grains. The recovery of oxygen content in superconducting layers was examined for multilayer structures with CeO2 thin films. Enough oxygen was supplied to the upper and lower superconducting layers when the multilayer was cooled slowly in 3 × 10−4 Pa oxygen pressure after deposition. Resistively shunted junction type I-V characteristics were confirmed for interface-engineered ramp-edge junctions in a multilayer structure including four superconducting layers with CeO2 thin films.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable