Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T16:54:34.413Z Has data issue: false hasContentIssue false

Characterization of polymer materials using magnetic levitation

Published online by Cambridge University Press:  06 April 2020

Jun Xie
Affiliation:
The State Key Laboratory of Fluid Power and Mechatronic Systems, Key Lab of 3D Printing Process and Equipment of Zhejiang Province, Zhejiang University, Hangzhou 310027, China
Peng Zhao*
Affiliation:
The State Key Laboratory of Fluid Power and Mechatronic Systems, Key Lab of 3D Printing Process and Equipment of Zhejiang Province, Zhejiang University, Hangzhou 310027, China
Jianfeng Zhang
Affiliation:
The State Key Laboratory of Fluid Power and Mechatronic Systems, Key Lab of 3D Printing Process and Equipment of Zhejiang Province, Zhejiang University, Hangzhou 310027, China
Hongwei Zhou
Affiliation:
Research and Development Department, Tederic Machinery Co., Ltd, Hangzhou, 311124, China
Jianzhong Fu
Affiliation:
The State Key Laboratory of Fluid Power and Mechatronic Systems, Key Lab of 3D Printing Process and Equipment of Zhejiang Province, Zhejiang University, Hangzhou 310027, China
Lih-Sheng Turng
Affiliation:
Wisconsin Institute for Discovery, Department of Mechanical Engineering, University of Wisconsin–Madison, Madison, Wisconsin 53706, USA
*
a)Address all correspondence to this author. e-mail: pengzhao@zju.edu.cn
Get access

Abstract

The quality of the polymer raw material used in plastic processing methods is an important characteristic because it is one of the main factors in producing quality products. Therefore, the characterization of polymeric pellets in the polymer processing industry is very important to avoid using inferior materials. In general, differences in the interiors of polymeric pellets reflect differences in their densities. In this study, a high-sensitivity magnetic levitation method was used to characterize the polymeric pellets in four different occasions. The device used has a high sensitivity that can distinguish minute differences as small as of 0.0041 g/cm3 in density between different samples. In addition, the method can obtain a sample's density without knowing the weight and volume of the sample. This method can be used to characterize materials by testing only a single pellet, which is very useful for polymeric pellet characterization.

Information

Type
Article
Copyright
Copyright © Materials Research Society 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable