Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T01:18:18.290Z Has data issue: false hasContentIssue false

Combined out-of-plane and in-plane texture control in thin films using ion beam assisted deposition

Published online by Cambridge University Press:  31 January 2011

L. Dong
Affiliation:
Department of Materials Science and Engineering, The University of Michigan, Ann Arbor, Michigan 48109
D. J. Srolovitz
Affiliation:
Princeton Materials Institute and Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, New Jersey 08544
G. S. Was
Affiliation:
Department of Materials Science and Engineering, and Department of Nuclear Engineering and Radiological Sciences, The University of Michigan, Ann Arbor, Michigan 48109
Q. Zhao
Affiliation:
Department of Nuclear Engineering and Radiological Sciences, The University of Michigan, Ann Arbor, Michigan 48109
A. D. Rollett
Affiliation:
Department of Materials Science and Engineering, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213
Get access

Abstract

Complete control of the texture of a film during growth requires the ability to determine the in-plane and out-of-plane texture simultaneously. We present both computer simulation and experimental evidence for the simultaneous establishment of out-of-plane and in-plane texture during ion beam assisted deposition of aluminum. Channeling along 〈110〉 directions (60° from the normal) creates a {220} out-of-plane orientation rather than the thermodynamically preferred {111} orientation. The ion beam also aligned 〈220〉 directions within the plane of the film. Measured x-ray pole figures confirmed the presence of a strong out-of-plane texture and the presence of two main, twin-related, in-plane texture components. We theoretically demonstrated that it is impossible to completely control both the in-plane and out-of-plane texture with a single ion beam in high-symmetry crystals and two ion beams must be employed to ensure complete texture control.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable