Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T11:05:58.440Z Has data issue: false hasContentIssue false

Continuous microindentation of passivating surfaces

Published online by Cambridge University Press:  31 January 2011

Shankar K. Venkataraman
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455–0132
David L. Kohlstedt
Affiliation:
Department of Geology and Geophysics, University of Minnesota, Minneapolis, Minnesota 55455
William W. Gerberich
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455–0132
Get access

Abstract

Continuous microindentation tests performed on the electropolished surfaces of single crystal Fe (3 wt.% Si), known to have a thin passivation film, show a sharp discontinuity at a load of 1.8 mN. To this point, there was no apparent plastic deformation in the metal in that the loading and unloading curves exactly overlay each other. Stresses at the discontinuity were close to the theoretical strength of the metal. Elastic contact theories of Hertz and Love reproduced the elastic portion of the load-displacement curves. On removing the passivation film with a HCl solution, indentation tests yielded strengths nearly two orders of magnitude smaller. The strength recovered to near its initial value after the liquid evaporated and the passivation film re-formed.

Information

Type
Communications
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable