Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T02:36:20.605Z Has data issue: false hasContentIssue false

Cu films by partially ionized beam deposition for ultra large scale integration metallization

Published online by Cambridge University Press:  31 January 2011

Ki-Hwan Kim*
Affiliation:
Thin Film Technology Research Center, Korea Institute of Science and Technology, P.O. Box 131, Cheonryang, Seoul 130-650, Korea
Hong-Gui Jang
Affiliation:
Thin Film Technology Research Center, Korea Institute of Science and Technology, P.O. Box 131, Cheonryang, Seoul 130-650, Korea
Sung Han
Affiliation:
Thin Film Technology Research Center, Korea Institute of Science and Technology, P.O. Box 131, Cheonryang, Seoul 130-650, Korea
Hyung-Jin Jung
Affiliation:
Thin Film Technology Research Center, Korea Institute of Science and Technology, P.O. Box 131, Cheonryang, Seoul 130-650, Korea
Seok-Keun Koh
Affiliation:
Thin Film Technology Research Center, Korea Institute of Science and Technology, P.O. Box 131, Cheonryang, Seoul 130-650, Korea
Doo-Jin Choi
Affiliation:
Department of Ceramic Engineering, Yonsei University, Seoul 120-794, Korea
*
a) Author correspondence to this author.hama@kistmail.kist.re.kr
Get access

Abstract

Highly (111) oriented Cu films with a thickness around 1800 Å were prepared on Si(100) at room temperature by partially ionized beam deposition (PIBD) at pressure of 8 × 10-7-1 × 10-6 Torr. Effects of acceleration voltage (Va) between 0 and 4 kV on such properties as crystallinity, surface roughness, resistivity, etc. of the films have been investigated. The Cu films deposited by PIBD had only (111) and (200) planes, and the relative intensity ratio, I(111)/I(200) of the Cu films increased from 6.8 at Va = 0 kV to 37 at Va = 4 kV. There was no indication of impurities in the system from Auger electron spectroscopy (AES) analyses. A large increase in grain size of the films occurred with Va up to Va = 1 kV, but little increase occurred with Va > 1 kV. Surface roughness of the Cu films decreased with Va, and resistivity showed the same trends as that of the surface roughness. In the Cu films by PIBD, it is considered that changes of resistivity are mainly due to a surface scattering rather than a grain boundary scattering. The via holes, dimensions of which are 0.5 μm in diameter and 1.5 μm in depth, in the Cu films made at Va = 4 kV were completely filled without voids. Interface adhesion of the Cu film on Si(100) deposited at Va = 3 kV was five times greater than that of Cu film deposited at Va = 0 kV, as determined by a scratch test.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable