Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T11:24:31.712Z Has data issue: false hasContentIssue false

Densification process in undoped zinc oxide

Published online by Cambridge University Press:  31 January 2011

K. Kobayashi
Affiliation:
Laboratoire de Chimie du Solide du CNRS, 351, cours de la Libération, 33405 Talence Cedex, France
P. Dordor
Affiliation:
Laboratoire de Chimie du Solide du CNRS, 351, cours de la Libération, 33405 Talence Cedex, France
J. P. Bonnet
Affiliation:
Laboratoire de Chimie du Solide du CNRS, 351, cours de la Libération, 33405 Talence Cedex, France
R. Salmon
Affiliation:
Laboratoire de Chimie du Solide du CNRS, 351, cours de la Libération, 33405 Talence Cedex, France
P. Hagenmuller
Affiliation:
Laboratoire de Chimie du Solide du CNRS, 351, cours de la Libération, 33405 Talence Cedex, France
Get access

Abstract

An original preparation of ZnO is described where the powder is obtained by precipitaton from zinc nitrate in aqueous solution followed by a calcination. Scanning electron microscopy reveals a close relation between the initial density and the morphology of the powder, the latter being also strongly dependent on the calcining conditions. The investigation of the densification process shows the extreme sensitivity of the final density to sintering conditions. A physical model based on the competitive influences of shrinkage and evaporation successfully describes the observed phenomena.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1987

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable