Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-19T05:23:18.062Z Has data issue: false hasContentIssue false

Direct mapping of deformation in punch indentation and correlation with slip line fields

Published online by Cambridge University Press:  31 January 2011

T.G. Murthy
Affiliation:
Center for Materials Processing and Tribology, School of Industrial Engineering, Purdue University, West Lafayette, Indiana 47906-2023
J. Madariaga
Affiliation:
Center for Materials Processing and Tribology, School of Industrial Engineering, Purdue University, West Lafayette, Indiana 47906-2023; and Department of Manufacturing, Mondragon University, Loramendi, 4-20500 Mondragon, Spain
S. Chandrasekar*
Affiliation:
Center for Materials Processing and Tribology, School of Industrial Engineering, Purdue University, West Lafayette, Indiana 47906-2023
*
a) Address all correspondence to this author. e-mail: chandy@ecn.purdue.edu
Get access

Abstract

Deformation field parameters in plane-strain indentation of a perfectly plastic solid with a punch have been mapped using particle image velocimetry, a correlation-based image analysis technique. Measurements of velocity and strain rate over a large area have shown that the deformation resembles that of the slip line field of Prandtl. A zone of dead metal is found to exist underneath the indenter adjoining which is a transition region of material flow similar to the centered-fan region in the slip line field. Shear bands demarcate the boundaries of these deformation regions. The observations suggest that a representative strain rate may be assigned to the indentation. By integrating the strain rate field along particle trajectories, the strains in the indentation region have been estimated. The strain values are seen to be large, 0.5 to 4, over a region extending to about twice the indenter half-width. A pocket of large strain, ∼4, is found to exist close to the edge of the indenter–specimen contact. Prandtl’s slip line field is modified based on the observations and used to estimate the strain field. The measurements of the deformation parameters are found to compare mostly favorably with the predictions of the slip line field and prior observations of indentation. The implications of these findings for analysis and interpretation of indentation hardness are briefly discussed.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable