Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T02:08:45.723Z Has data issue: false hasContentIssue false

Dynamic force microscopy study of the microstructural evolution of pulsed laser deposited ultrathin Ni and Ag films

Published online by Cambridge University Press:  31 January 2011

Prashant Kumar
Affiliation:
School of Physics, University of Hyderabad, Hyderabad-500046, India
M. Ghanashyam Krishna*
Affiliation:
School of Physics, University of Hyderabad, Hyderabad-500046, India; and Department of Engineering Sciences, Oxford University, Oxford OX1 3PJ, United Kingdom
A.K. Bhatnagar
Affiliation:
School of Physics, University of Hyderabad, Hyderabad-500046, India
A.K. Bhattacharya
Affiliation:
Department of Engineering Sciences, Oxford University, Oxford OX1 3PJ, United Kingdom
*
a)Address all correspondence to this author. e-mail: mgksp@uohyd.ernet.in
Get access

Abstract

Ultrathin films (6–10 nm) of silver and nickel were deposited by pulsed laser deposition (PLD) in high vacuum (1 × 10−6 mbar). Microstructural evolution of these films as function of incident laser energy, substrate temperature, substrate material [borosilicate glass, fused silica, MgO(100) and Si (311)] and target–substrate distance was studied in detail using dynamic force microscopy. It is shown that with increase in laser energy incident on the target, there is a substantial increase in particle size in the film. The effect of increased laser energy on microstructure is much more drastic than that for the increase of substrate temperature. In general, denser packing of nanoparticles and increased clustering have been observed at elevated substrate temperature. Increase in laser energy gives rise to higher average grain size, packing density, and clustering in comparison to substrate temperature. It is observed that the aspect ratio of grains is dependent on incident laser fluence and substrate temperature, but more drastically on the substrate material. Substrate coverage and aspect ratio of the grains are particularly dependent on the nature of crystallinity of the substrates. It is demonstrated that PLD provides a greater degree of microstructural manipulation than other physical vapor deposition techniques.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable