Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T03:15:09.744Z Has data issue: false hasContentIssue false

Electromigration study in the eutectic SnBi solder joint on the Ni/Au metallization

Published online by Cambridge University Press:  01 April 2006

Long-tai Chen
Affiliation:
Department of Chemical Engineering, National Chung-Hsing University,Taichung 402, Taiwan, Republic of China
Chih-ming Chen*
Affiliation:
Department of Chemical Engineering, National Chung-Hsing University,Taichung 402, Taiwan, Republic of China
*
a) Address all correspondence to this author. e-mail: chencm@dragon.nchu.edu.tw
Get access

Abstract

Microstructural evolution and interfacial reaction in the eutectic SnBi solder joint on the Ni/Au metallization with and without the current stressing of 6.5 × 103 A/cm2 at 70 °C for 5 to 15 days were investigated. Electromigration is found to have significant effects not only on the phase formation at the joint interface but also on the phase coarsening and mass accumulation of Bi in the solder. In the solder joint without the current stressing, only a thin Ni3Sn4 phase was formed at the joint interface. For the solder joint with the current stressing, in addition to the Ni3Sn4 phase, a thick Au–Ni–Bi–Sn phase was formed at the joint interface after 10 days. However, the Au–Ni–Bi–Sn phase was not observed at the anode-side joint interface after 15 days of current stressing. Coarsening of the Bi-rich grain in the solder joint with the current stressing was much faster than that without the current stressing. Mass accumulation of Bi was observed at the anode side of the solder joint with the current stressing and the thickness of the Bi-rich accumulation layer increased with current stressing time. Based on the accumulation rate of the Bi-rich layer and the growth rate of the Bi-rich grain, the product of diffusivity and effective charge number of Bi in the eutectic SnBi solder is calculated to be 4.72 × 10−10 cm2/s.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable