Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T14:32:32.077Z Has data issue: false hasContentIssue false

Electrostatic force microscopy studies of boron-doped diamond films

Published online by Cambridge University Press:  31 January 2011

S. Gupta*
Affiliation:
Department of Electrical and Computer Engineering, University of Missouri, Columbia, Missouri 65211
O.A. Williams
Affiliation:
Institute for Materials Research, Universiteit Hasselt, BE-3590 Diepenbeek, Belgium
E. Bohannan
Affiliation:
Department of Chemistry, University of Missouri, Rolla, Missouri 65409
*
a)Address all correspondence to this author. e-mail: guptas@missouri.edu, sgup@rocketmail.com
Get access

Abstract

Much has been learned from electrochemical properties of boron-doped diamond (BDD) thin films synthesized using microwave plasma-assisted chemical vapor deposition about the factors influencing electrochemical activity, but some characteristics are still not entirely understood, such as its electrical conductivity in relation with microscale structure. Therefore, to effectively utilize these materials, understanding both the microscopic structure and physical (electrical, in particular) properties becomes indispensable. In addition to topography using atomic force microscopy, electrostatic force microscopy (EFM) in phase mode measuring the long-range electrostatic force gradients, helps to map the electrical conductivity heterogeneity of boron-doped micro-/nanocrystalline diamond surfaces. The mapping of electrical conductivity on boron doping and bias voltage is investigated. Experimental results showed that the BDD films’ surfaces were partially rougher with contrast of conductive regions (areas much less than 1 μm2 in diameter), which were uniformly distributed. Usually, the EFM signal is a convolution of topography and electrostatic force, and the phase contrast was increased with boron doping. At the highest boron doping level, the conductive regions exhibited quasi-metallic electrical properties. Moreover, the presence of a “positive–negative–positive” phase shift along the line section indicates the presence of “insulating–conducting–insulating” phases, although qualitative. Furthermore, the electrical properties, such as capacitance and dielectric constants at operating frequency, were quantitatively evaluated through modeling the bias-dependent phase measurements using simple and approximate geometries. It was found that decreasing grain size (or increasing the boron concentration) lowers the dielectric constant, which is attributed to the change in the crystal field caused by surface bond contraction of the nanosized crystallites. These findings are complemented and validated with scanning electron microscopy, x-ray diffraction, and “visible” Raman spectroscopy revealing their morphology, structure, and carbon-bonding configuration (sp3 versus sp2), respectively. These results are significant in the development of electrochemical nano-/microelectrodes and diamond-based electronics.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable