Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T05:33:08.489Z Has data issue: false hasContentIssue false

Evaluation of the effectiveness of representative methods for determining Young's modulus and hardness from instrumented indentation data

Published online by Cambridge University Press:  01 January 2006

Dejun Ma
Affiliation:
Department of Mechanical Engineering, The Academy of Armored Forces Engineering,Beijing 100072, People's Republic of China
Taihua Zhang
Affiliation:
State Key Laboratory of Nonlinear Mechanics (LNM), Institute of Mechanics, Chinese Academy of Sciences, Beijing 100080, People's Republic of China
Chung Wo Ong*
Affiliation:
Department of Applied Physics and Materials Research Center, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, People's Republic of China
*
a)Address all correspondence to this author. e-mail: apacwong@inet.polyu.edu.hk
Get access

Abstract

The effectiveness of Oliver & Pharr's (O&P's) method, Cheng & Cheng's (C&C’s) method, and a new method developed by our group for estimating Young's modulus and hardness based on instrumented indentation was evaluated for the case of yield stress to reduced Young's modulus ratio (σy/Er) ≥ 4.55 × 10−4 and hardening coefficient (n) ≤ 0.45. Dimensional theorem and finite element simulations were applied to produce reference results for this purpose. Both O&P's and C&C's methods overestimated the Young's modulus under some conditions, whereas the error can be controlled within ±16% if the formulation was modified with appropriate correction functions. Similar modification was not introduced to our method for determining Young's modulus, while the maximum error of results was around ±13%. The errors of hardness values obtained from all the three methods could be even larger and were irreducible with any correction scheme. It is therefore suggested that when hardness values of different materials are concerned, relative comparison of the data obtained from a single standard measurement technique would be more practically useful. It is noted that the ranges of error derived from the analysis could be different if different ranges of material parameters σy/Er and n are considered.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable