Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T20:32:51.169Z Has data issue: false hasContentIssue false

Extracting elastic properties and prestress of a cell using atomic force microscopy

Published online by Cambridge University Press:  31 January 2011

C.Y. Zhang*
Affiliation:
Shenzhen Institute of Advanced Technology, Chinese Academy of Science, Shenzhen 518067, China
Y.W. Zhang
Affiliation:
Department of Materials Science and Engineering, National University of Singapore, Singapore 119260
*
a) Address all correspondence to this author. e-mail: chunyu@nus.edu.sg
Get access

Abstract

An analytical solution was derived for the indentation of a cell using atomic force microscopy. It was found that the contribution of the cell membrane to the overall indentation stiffness is dependent on the size of the indenter. When a small indenter [for example, an atomic force microscopy (AFM) tip] is used to probe the mechanical properties of cells, the cell membrane and its prestress were important in interpreting indentation data. The solution allows the partition of contributions from the membrane and the interior soft phase. The apparent elastic modulus of the cell and the prestress of the cell membrane can be extracted. In addition, the modulus of the cell membrane could be estimated from the extracted apparent modulus if the interior soft phase of the cell was known and vice versa. However, when a large indenter is used (for example, a microbead attached to the cantilever beam of the AFM), the contribution of the cell membrane is negligible.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable