Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T22:33:48.947Z Has data issue: false hasContentIssue false

Fabrication and structural analysis of ZnO coated fiber optic phase modulators

Published online by Cambridge University Press:  31 January 2011

G. R. Fox
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Laboratoire de Céramique, Lausanne, Switzerland, CH-1015
N. Setter
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Laboratoire de Céramique, Lausanne, Switzerland, CH-1015
H. G. Limberger
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Laboratoire d'Optique Appliquée, Lausanne, Switzerland, CH-1015
Get access

Abstract

Fiber optic modulators were fabricated by coating optical fibers with electrode and piezoelectric ZnO layers. The techniques of piezoelectric fiber optic modulator (PFOM) fabrication are presented, and the microstructure and crystallographic texture of the coatings are analyzed. In order to produce thick (approximately 5 μm) ZnO coatings, it was necessary to study the reactive dc magnetron sputtering process in O2/Ar gas mixtures under conditions close to the transition between an oxidized and nonoxidized Zn target surface. In situ quartz crystal microbalance measurements of the deposition rate revealed thee distinct regions in the deposition rate (R) vs oxygen partial pressure behavior, at constant total pressure, for sputtering under conditions that provided an oxidized Zn target surface. Additionally, a transition between oxygen and argon dominated sputtering as observed by varying the sputtering pressure while maintaining a constant The transition between oxygen and argon dominated sputtering influences R to varying extents within the three R vs regions for an oxidized target surface. Correlations among the cathode current and voltage, deposition rate, and gas flow rate are presented to give a better understanding of the reactive sputtering processes occurring at the oxidized Zn target surface. Sputtering conditions optimized for a high ZnO deposition rate were used to produce 〈001〉 radially oriented ZnO fiber coatings for PFOM devices that can produce optical phase shifts as large as 0.38 rad/V.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable