Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T11:44:36.055Z Has data issue: false hasContentIssue false

Failure by simultaneous grain growth, strain localization, and interface debonding in metal films on polymer substrates

Published online by Cambridge University Press:  31 January 2011

Joost Vlassak*
Affiliation:
School of Engineering and Applied Sciences, Harvard University, Cambridge, Massachusetts 02138
*
a) Address all correspondence to this author. e-mail: vlassak@esag.harvard.edu
Get access

Abstract

In a previous paper, we have demonstrated that a microcrystalline copper film well bonded to a polymer substrate can be stretched beyond 50% without cracking. The film eventually fails through the coevolution of necking and debonding from the substrate. Here we report much lower strains to failure (approximately 10%) for polymer-supported nanocrystalline metal films, the microstructure of which is revealed to be unstable under mechanical loading. We find that strain localization and deformation-associated grain growth facilitate each other, resulting in an unstable deformation process. Film/substrate delamination can be found wherever strain localization occurs. Therefore, we propose that three concomitant mechanisms are responsible for the failure of a plastically deformable but microstructurally unstable thin metal film: strain localization at large grains, deformation-induced grain growth, and film debonding from the substrate.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable