Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T19:03:14.696Z Has data issue: false hasContentIssue false

Fiber push-out testing apparatus for elevated temperatures

Published online by Cambridge University Press:  03 March 2011

Jeffrey I. Eldridge
Affiliation:
NASA Lewis Research Center, Cleveland, Ohio 44135
Ben T. Ebihara
Affiliation:
NASA Lewis Research Center, Cleveland, Ohio 44135
Get access

Abstract

A newly developed apparatus has been designed for performing fiber push-out testing on continuous fiber-reinforced composites at elevated temperatures. This test measures the force at which a fiber resists being pushed by a flat-bottomed indenter moving at a constant speed. The applied load versus time curve characterizes the fiber debonding and sliding behavior. Extending measurements to elevated temperatures required incorporating sample/indenter heating in a nonoxidizing environment. With this new apparatus, fiber push-out tests have been performed up to 1100 δC in a vacuum of 10-6 Torr. A line-of-sight to the sample is maintained during the test which allows video monitoring of the push-out process. Results are shown for SCS-6 SiC fiber-reinforced Ti-24Al-llNb (at. %) and Ti-15V-3Cr-3Sn-3Al (at. %) matrix composites. The results are discussed in terms of residual stresses, interfacial wear, matrix ductility, and changing modes of interfacial failure. The effect of temperature-dependent interfacial wear on the interfacial roughness contribution to frictional shear stresses during fiber sliding is examined.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable