Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T15:26:48.158Z Has data issue: false hasContentIssue false

Formation of patterned microstructures of polycrystalline ceramics from precursor polymers using micromolding in capillaries

Published online by Cambridge University Press:  31 January 2011

Weng Sing Beh
Affiliation:
Department of Chemistry, University of Washington, Seattle, Washington 98195
Younan Xia
Affiliation:
Department of Chemistry, University of Washington, Seattle, Washington 98195
Dong Qin
Affiliation:
Center for Nanotechnology, University of Washington, Seattle, Washington 98195
Get access

Abstract

Micromolding in capillaries has been used to generate patterned microstructures of ZrO2 or SnO2 from its polymeric precursor. After patterning, the amorphous precursor was converted into the desired polycrystalline ceramic material by calcination in air at 460 °C. The final phase for each ceramic material was determined by powder x-ray diffraction. The shrinkage of the precursor material during pyrolysis was investigated by scanning electron microscopy and atomic force microscopy. These ceramic microstructures could be either supported on solid substrates or released as freestanding fibers and membranes. Their lateral dimensions could be as small as approximately 500 nm.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable