Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T08:41:50.525Z Has data issue: false hasContentIssue false

Improving sol-gel Yba2Cu3O7−δ film morphology using high-boiling-point solvents

Published online by Cambridge University Press:  31 January 2011

J. T. Dawley
Affiliation:
Sandia National Laboratories, Albuquerque, New Mexico 87185
P. G. Clem
Affiliation:
Sandia National Laboratories, Albuquerque, New Mexico 87185
M. P. Siegal
Affiliation:
Sandia National Laboratories, Albuquerque, New Mexico 87185
D. R. Tallant
Affiliation:
Sandia National Laboratories, Albuquerque, New Mexico 87185
D. L. Overmyer
Affiliation:
Sandia National Laboratories, Albuquerque, New Mexico 87185
Get access

Abstract

The effect of high-boiling-point solvent addition on the morphology of low-p(O2) processed, sol-gel YBa2Cu3O7−δ (YBCO) films is discussed. Proper selection and addition of a high-boiling-point solvent prevents film roughening during precursor pyrolysis, while permitting at least a tenfold reduction in pyrolysis time compared to standard film processing in air or O2. Use of such solvents appears to increase film plasticity, avoiding elastic compressive stress related buckling. High-quality YBCO films on 〈100〉 LaAlO3 with a critical current density (Jc) ∼ 3–4 MA/cm2 at 77 K, are routinely crystallized with this new sol-gel process. Diethanolamine-based, sol-gel YBCO films deposited on sol-gel SrTiO3-buffered 〈100〉 Ni have Jc(77 K) > 1 MA/cm2, demonstrating a route toward all-sol-gel superconducting wires.

Information

Type
Rapid Communications
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable