Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-18T03:51:29.865Z Has data issue: false hasContentIssue false

Length-scale-based hardening model for ultra-small volumes

Published online by Cambridge University Press:  01 October 2004

J.M. Jungk*
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455
W.M. Mook
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455
M.J. Cordill
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455
M.D. Chambers
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455
W.W. Gerberich
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455
D.F. Bahr
Affiliation:
Department of Mechanical and Materials Engineering, Washington State University, Pullman, Washington 99164
N.R. Moody
Affiliation:
Microsystems and Materials Mechanics, Sandia National Laboratories, Livermore, California, 94550
J.W. Hoehn
Affiliation:
Seagate Technology LLC, Minneapolis, Minnesota 55435
*
a) Address all correspondence to this author. e-mail: jungk@cems.umn.edu
Get access

Abstract

Understanding the hardening response of small volumes is necessary to completely explain the mechanical properties of thin films and nanostructures. This experimental study deals with the deformation and hardening response in gold and copper films ranging in thickness from 10 to 400 nm and silicon nanoparticles with particle diameters less than 100 nm. For very thin films of both gold and copper, it was found that hardness initially decreases from about 2.5 to 1.5 GPa with increasing penetration depth. Thereafter, an increase occurs with depths beyond about 5–10% of the film thickness. It is proposed that the observed minima are produced by two competing mechanisms. It is shown that for relatively deep penetrations, a dislocation back stress argument reasonably explains the material hardening behavior unrelated to any substrate composite effect. Then, for shallow contacts, a volume-to-surface length scale argument relating to an indentation size effect is hypothesized. A simple model based on the superposition of these two mechanisms provides a reasonable fit to the experimental nanoindentation data.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable