Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T03:58:12.698Z Has data issue: false hasContentIssue false

Micro-Indentation of Aluminum Processed by Equal Channel Angular Extrusion

Published online by Cambridge University Press:  03 March 2011

Fuqian Yang*
Affiliation:
Department of Chemical and Materials Engineering, University of Kentucky, Lexington, Kentucky 40506
Lingling Peng
Affiliation:
Department of Chemical and Materials Engineering, University of Kentucky, Lexington, Kentucky 40506
Kenji Okazaki
Affiliation:
Department of Chemical and Materials Engineering, University of Kentucky, Lexington, Kentucky 40506
*
a)Address all correspondence to this author. e-mail: fyang0@engr.uky.edu
Get access

Abstract

The near-surface deformation of equal-channel angular extruded (ECAE) pure aluminum was investigated using the micro-indentation technique. Compared with fully annealed Al samples, there is a distinguishable difference in the indentation deformation. The unloading slope of the ECAE deformed Al after a short unloading period was found to be less than that of the annealed samples due to plastic recovery. Work hardening was observed, which depended on the history of local deformation. A new relationship between the plastic energy dissipated in the indentation and the applied load was derived, which is supported by the experimental results.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable