Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T08:22:53.545Z Has data issue: false hasContentIssue false

Microstructural evolution and mechanical properties of gas-pressure-sintered Si3N4 with Yb2O3 as a sintering aid

Published online by Cambridge University Press:  31 January 2011

Ki-Min Lee
Affiliation:
Creative Research Center for Microstructural Science of Materials, School of Materials Science and Engineering, Seoul National University, Seoul, 151–742, Korea
Won-Ho Lee
Affiliation:
Creative Research Center for Microstructural Science of Materials, School of Materials Science and Engineering, Seoul National University, Seoul, 151–742, Korea
Young-Hag Koh
Affiliation:
Creative Research Center for Microstructural Science of Materials, School of Materials Science and Engineering, Seoul National University, Seoul, 151–742, Korea
Jong-Jin Choi
Affiliation:
Creative Research Center for Microstructural Science of Materials, School of Materials Science and Engineering, Seoul National University, Seoul, 151–742, Korea
Hyoun-Ee Kim
Affiliation:
Creative Research Center for Microstructural Science of Materials, School of Materials Science and Engineering, Seoul National University, Seoul, 151–742, Korea
Seung Su Baek
Affiliation:
Agency for Defense Development, Yuseong P.O. Box 35–4, Taejon, 305–600, Korea
Get access

Abstract

Microstructural evolution and mechanical properties of gas-pressure-sintered Si3N4 with 4 wt% Yb2O3 as a sintering aid were investigated. The microstructure was not uniform throughout the specimen. Extremely large elongated grains were formed at the outer region near the surface, while relatively small elongated grains were formed at the inner region of the specimen. The outer region expanded inward with the sintering time. Mechanical properties, such as flexural strength, fracture toughness, and R-curve behavior of the specimens were strongly influenced by these variations in microstructure. The fracture toughness and the R-curve behavior of the outer region were higher than those of the inner region of the same specimen. On the other hand, the strength of the inner region was higher than that of the outer region. By controlling the relative thickness of each region, Si3N4 specimens having functionally graded microstructure were obtained. The Si3N4 with such microstructure exhibited high strength, high fracture toughness, and good flaw tolerance at the same time.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable