Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T08:32:24.448Z Has data issue: false hasContentIssue false

Microstructure and adhesion properties of Sn–0.7Cu/Cu solder joints

Published online by Cambridge University Press:  31 January 2011

Kyoo-Sik Bae
Affiliation:
Department of Electronic Materials Engineering, The University of Suwon, Suwon, Kyunggi-do, 445–743, Korea
Si-Jung Kim
Affiliation:
Department of Electronic Materials Engineering, The University of Suwon, Suwon, Kyunggi-do, 445–743, Korea
Get access

Abstract

The microstructure and adhesion strength of the Sn–0.7Cu/Cu solder joints were examined. The acicular η(Cu6Sn5)-phase was formed inside the solder and at the solder/Cu interface, mostly in the direction normal to the interface. Compared to the Sn–3.5Ag alloy, the Sn–0.7Cu solder showed comparable wettability, but lower microhardness and joint strength. After aging, the acicular η-phase grew into a round and scallop-shaped morphology, thin є(Cu3Sn)-phase evolved just above the Cu substrate, and the joint strength decreased linearly with aging time.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable