Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T04:04:58.839Z Has data issue: false hasContentIssue false

Microstructure and compressive properties of chill-cast Mg–Al–Ca alloys

Published online by Cambridge University Press:  01 March 2006

Ling-Ling Shi
Affiliation:
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, People’s Republic of China
Han Ma
Affiliation:
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, People’s Republic of China
Teng Liu
Affiliation:
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, People’s Republic of China
Jian Xu
Affiliation:
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, People’s Republic of China
En Ma*
Affiliation:
Department of Materials Science and Engineering, The Johns Hopkins University, Baltimore, Maryland 21218
*
a) Address all correspondence to this author. e-mail: ema@jhu.edu
Get access

Abstract

Mg82Al8Ca10 was determined to be a pseudo-binary eutectic composition [liquid solidifying into α–Mg and (Mg,Al)2Ca in the Mg–Al–Ca ternary system with a eutectic melting temperature of 789 K]. A series of Mgx(Al0.44Ca0.56)100−x alloys, where 75 ≤ x ≤ 95, were cast into Φ4 mm rods using copper mold casting. The eutectic alloy exhibits the highest fracture strength, σf = 609 MPa. For 75 ≤ x ≥ 79, the alloys have hypereutectic microstructures with Mg2Ca as the primary phase, and σf is reduced together with diminishing plasticity. For hypoeutectic alloys with 86 ≤ x ≥ 95, the volume fraction of the primary α–Mg dendrites dispersed in the eutectic matrix increases with increasing x, resulting in a gradual decrease of the yield and fracture strengths but improved plastic strain to as large as 9%. The refined microstructures created in bulk samples via chill casting can lead to a good combination of strength and plasticity, with specific strength superior to commercial Mg alloys.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable