Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-18T18:45:57.909Z Has data issue: false hasContentIssue false

The microstructure and dealloying kinetics of a Cu-Mn alloy

Published online by Cambridge University Press:  03 March 2011

Un-Sig Min
Affiliation:
Department of Mechanical Engineering, Materials Science Program, University of Rochester, Rochester, New York 14627-0133
James C.M. Li
Affiliation:
Department of Mechanical Engineering, Materials Science Program, University of Rochester, Rochester, New York 14627-0133
Get access

Abstract

Porous copper was produced by electrolytic dealloying of a Cu-Mn alloy (Incramute: Cu, 40-48 wt. % Mn, 1.4-2.3 wt. % Al) conducted in a 0.3 N-NaCl solution at a potential of −0.2 V (SCE). The dealloying time needed for the as-received cold-rolled specimen (50 h) is shorter than that of the annealed specimen (850 °C for 2 h). The pore size, about 1 μm, of the dealloyed cold-rolled specimen is bigger than that, about 0.1 μm, of the dealloyed specimen after annealing. This is probably because annealing reduced the phase inhomogeneity and removed the rolling effects.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable