Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T05:46:24.694Z Has data issue: false hasContentIssue false

Microstructure and mechanical behavior of Al–Mg/Ni–P composites

Published online by Cambridge University Press:  31 January 2011

V. Raman
Affiliation:
IBM Corporation, General Products Division, San Jose, California 95193
Get access

Abstract

The microstructure and mechanical behavior of electroless deposited Ni–P on Al–Mg substrates were investigated. The microstructures of the as-deposited and annealed samples were characterized through optical and scanning electron microscopy. Hardness measurements were made both on the Al–Mg substrate and the Ni–P coating using a depth sensing hardness machine. The plastic deformation behavior of the composites was studied and the results show that the initial deformation is accompanied by the appearance of serrations on load-displacement curves. Decohesion of the hard Ni–P takes place at large strains. An estimate of the ultimate shear strength of the Al–Mg/Ni–P interface was made and the strength of the interface was determined to be −0.45 GPa. The tribological properties of the amorphous Ni–P were studied using ball-on-disk and slider-on-disk tests. In particular, the influences of humidity, surface roughness, and heat treatment on friction and durability of the coatings were investigated.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable