Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T18:21:42.193Z Has data issue: false hasContentIssue false

Partial melting and segregation behavior in a superplastic Si3N4/Al–Mg alloy composite

Published online by Cambridge University Press:  03 March 2011

J. Koike*
Affiliation:
Department of Mechanical Engineering. Oregon State University, Corvallis, Oregon 97331
M. Mabuchi
Affiliation:
National Industrial Research Institute of Nagoya, 1 Hirate-cho, Kita-ku, Nagoya 462, Japan
K. Higashi
Affiliation:
Department of Mechanical Systems Engineering, College of Engineering, University of Osaka Prefecture, Sakai, Osaka 593, Japan
*
a)Present address: Department of Materials Science, Faculty of Engineering, Tohoku University, Sendai 980, Japan.
Get access

Abstract

AJ-Mg alloy (5052) composite reinforced with Si3N4 particulates was investigated by transmission electron microscopy and electron energy loss spectroscopy. Partial melting was observed at matrix/reinforcement interfaces and matrix grain boundaries at a temperature near an optimum superplastic temperature. Segregation of solute elements (Mg and Si) was observed at the interfaces and grain boundaries. Both partial melting and solute segregation were found to depend on grain boundaries. The obtained results were explained by a decrease of the solidus temperature due to segregation whose extent depends on the type of the grain boundary structure.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable