Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T21:13:23.452Z Has data issue: false hasContentIssue false

Partially ionized beam deposition of oriented films

Published online by Cambridge University Press:  31 January 2011

A. S. Yapsir
Affiliation:
Center for Integrated Electronics and Physics Department, Rensselaer Polytechnic Institute, Troy, New York 12180
L. You
Affiliation:
Center for Integrated Electronics and Physics Department, Rensselaer Polytechnic Institute, Troy, New York 12180
T. -M. Lu
Affiliation:
Center for Integrated Electronics and Physics Department, Rensselaer Polytechnic Institute, Troy, New York 12180
M. Madden
Affiliation:
Intel Corporation, Santa Clara, California 95051
Get access

Abstract

The microstructure of Al films deposited on SiO2 using the partially ionized beam (PIB) deposition technique is studied. It is shown that by employing less than 1% ions (ion-to-atom ratio) derived from the evaporated material and about 1–2 kV bias voltage at the substrate during deposition, one can grow highly (111) oriented Al films at room temperature. For a fixed bias potential, the value of the ion-to-atom ratio to achieve the optimum orientation effect is determined. At the optimum condition for the (111) preferred orientation growth, no significant enhancement in the grain size is observed. It is also found that a drastic reduction in the degree of the preferred orientation occurs when the films are deposited at a substrate temperature greater than 150 °C.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable