Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T00:41:00.360Z Has data issue: false hasContentIssue false

Silicate bonded unsintered ceramics of Bayer process waste

Published online by Cambridge University Press:  31 January 2011

Arun S. Wagh*
Affiliation:
Materials Laboratory, Physics Department, University of the West Indies, Mona, Kingston 7, Jamaica
Victor E. Douse
Affiliation:
Materials Laboratory, Physics Department, University of the West Indies, Mona, Kingston 7, Jamaica
*
a)Address correspondence to this author at Materials and Components Technology Division, Argonne National Laboratory, 9700 South Cass Avenue, Argonne, Illinois 60439.
Get access

Abstract

Sodium silicates are investigated to enhance the strengths of Bayer process muds and develop structural ceramics without sintering. With an impregnation of sodium silicate from 2% to 10% concentration in red mud, the fracture toughness is enhanced from 0.2 to 0.9 MPa. Compression strengths of 25.1 MPa (3628 psi) have been attained with red mud at 10% silicate concentration. Similar enhancements by a factor of 4 to 5 have been obtained for modulus of rupture and Brinell hardness number. It is shown that these properties do not deteriorate in acidic and neutral environment in water, implying stability to weathering conditions. SEM investigations reveal elongated crystal formation, possibly of aluminum and iron silicates in the aggregate. These crystals act like whiskers enhancing the strength. The process is applicable for development of low-cost construction components.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable