Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T20:35:00.794Z Has data issue: false hasContentIssue false

Size effects in LiF micron-scale single crystals of low dislocation density

Published online by Cambridge University Press:  31 January 2011

Edward M. Nadgorny*
Affiliation:
General Dynamics Information Technology, Dayton, Ohio 45431-1231
Dennis M. Dimiduk
Affiliation:
Air Force Research Laboratory, Materials and Manufacturing Directorate, Wright-Patterson Air Force Base, Ohio 45433-7817
Michael D. Uchic
Affiliation:
Air Force Research Laboratory, Materials and Manufacturing Directorate, Wright-Patterson Air Force Base, Ohio 45433-7817
*
a)Address all correspondence to this author. e-mail: nadgorny@mtu.edu On sabbatical leave from Physics Department, Michigan Technological University, Houghton, MI 49931.
Get access

Abstract

This study examines the size-dependent deformation response of pure LiF single crystals using microcompression testing. Microcrystals with an 〈001〉 orientation and sample diameter D ranging from 1 to 20 μm were fabricated by focused ion beam (FIB)-milling from bulk crystals having a low initial dislocation density. Both as-grown and γ-irradiated crystals were examined to characterize the effect of an increased point defect density on the size-affected plastic flow response. Similar to previously studied face-centered cubic (FCC)-derivative metals, both types of LiF microcrystals exhibit typical size-dependent plastic flow behavior: a dramatic size-dependent and statistically varying flow stress, atypically high strain hardening rates at small plastic strains, and fast intermittent strain bursts. The size-dependent strengthening obeys a power law, σ ∼ D−m, where m ≈ 0.8, and this rapid hardening results in engineering flow stresses of 650 MPa in 1-μm samples. The findings are evaluated against possible dislocation mechanisms that could be responsible for the observed size effects.

Information

Type
Outstanding Symposium Papers
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable