Hostname: page-component-7b7567c8c-p67k6 Total loading time: 0 Render date: 2026-11-19T10:36:08.971Z Has data issue: false hasContentIssue false

Stress development and relaxation in copper films during thermal cycling

Published online by Cambridge University Press:  31 January 2011

M.D. Thouless
Affiliation:
IBM Research Division, T.J. Watson Research Center, Yorktown Heights, New York 10598
J. Gupta
Affiliation:
IBM Research Division, T.J. Watson Research Center, Yorktown Heights, New York 10598
J.M.E. Harper
Affiliation:
IBM Research Division, T.J. Watson Research Center, Yorktown Heights, New York 10598
Get access

Abstract

The reliability of integrated-circuit wiring depends strongly on the development and relaxation of stresses that promote void and hillock formation. In this paper an analysis based on existing models of creep is presented that predicts the stresses developed in thin blanket films of copper on Si wafers subjected to thermal cycling. The results are portrayed on deformation-mechanism maps that identify the dominant mechanisms expected to operate during thermal cycling. These predictions are compared with temperature-ramped and isothermal stress measurements for a 1 μm-thick sputtered Cu film in the temperature range 25–450 °C. The models successfully predict both the rate of stress relaxation when the film is held at a constant temperature and the stress-temperature hysteresis generated during thermal cycling. For 1 μm-thick Cu films cycled in the temperature range 25–450 °C, the deformation maps indicate that grain-boundary diffusion controls the stress relief at higher temperatures (>300 °C) when only a low stress can be sustained in the films, power-law creep is important at intermediate temperatures and determines the maximum compressive stress, and that if yield by dislocation glide (low-temperature plasticity) occurs, it will do so only at the lowest temperatures (<100 °C). This last mechanism did not appear to be operating in the film studied for this project.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable