Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T20:35:22.273Z Has data issue: false hasContentIssue false

Structural characterization of sputter-deposited LaNiO3 thin films on Si substrate by x-ray reflectivity and diffraction

Published online by Cambridge University Press:  31 January 2011

Hsin-Yi Lee
Affiliation:
Department of Materials Science and Engineering, National Tsing Hua University, and Research Division, Synchrotron Radiation Research Center, Hsinchu 30077, Taiwan, Republic of China
Tai-Bor Wu
Affiliation:
Department of Materials Science and Engineering, National Tsing Hua University, Hsinchu 30043, Taiwan, Republic of China
Get access

Abstract

X-ray reflectivity and diffraction were applied to characterize the highly (100)-textured thin films of LaNiO3, which were deposited on Si substrate via radio frequency magnetron sputtering at temperatures ranging from 250 to 450 °C. Two interference fringes of different period were observed from the reflectivity curves, and the fitting result indicates that in addition to the normal lanthanum-nickel oxide layer, a transition layer, which has a larger mass density than the previous one, exists in the sputter-deposited films. A comparison of the measured x-ray diffraction intensity with that calculated from layer thickness and mass density obtained from reflectivity data indicates that the transition layer is noncrystalline. The x-ray diffraction result also shows that there is a significant decrease of (100) diffraction intensity relative to that of (200) as increasing the deposition temperature. Using the reflectivity and diffraction data along with results of electron diffraction and film composition analysis from our other studies, such a change of relative intensity between the two diffraction peaks is attributed to the increasing content of two also highly textured La-rich phases, i.e., (110)-textured La4Ni3O10 and (100)-textured La2NiO4, in addition to the LaNiO3.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable