Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-15T23:58:42.528Z Has data issue: false hasContentIssue false

Subsurface cracking during indentation on hybrid coatings on polycarbonate

Published online by Cambridge University Press:  31 January 2011

Victor A Soloukhin
Affiliation:
Laboratory of Solid State and Materials Chemistry, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands
José C.M. Brokken-Zijp
Affiliation:
Laboratory of Solid State and Materials Chemistry, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands, and Dutch Polymer Institute, P.O. Box 902, 5600 AX Eindhoven, The Netherlands
Gijsbertus de With
Affiliation:
Laboratory of Solid State and Materials Chemistry, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands
Get access

Abstract

Subsurface cracking after nano- and Vickers indentation on transparent silica–(meth)acrylate hybrid coatings deposited on a polycarbonate substrate was observed for the first time. It appeared that after initiation at the interface, these cracks propagated toward the surface and in radial directions as the indentation load increased. It was found that, for chemically identical coatings, the thicker the coating, the higher load necessary to initiate these cracks. Subsurface cracks formed during nanoindentation occur at lower loads than the normally observed surface cracks and are accompanied by a very small change in the slope of the loading curve.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable