Hostname: page-component-7b7567c8c-jswmv Total loading time: 0 Render date: 2026-11-15T20:11:00.912Z Has data issue: false hasContentIssue false

Thermal and thermomechanical effects on defect evolution in an Al–Li superplastic alloy

Published online by Cambridge University Press:  26 July 2012

K. A. Padmanabhan
Affiliation:
Department of Materials Science, Darmstadt University of Technology, Petersenstr. 23, 64287 Darmstadt, Germany
A. G. Balogh
Affiliation:
Department of Materials Science, Darmstadt University of Technology, Petersenstr. 23, 64287 Darmstadt, Germany
W. Puff
Affiliation:
Institute of Technical Physics, Technical University Graz, A-8010 Graz, Austria
Get access

Extract

A commercial Al–Li alloy, in which the superplastic microstructure is developed by “strain-assisted continuous recrystallization” in early stages of flow, was studied using positron annihilation lifetime spectroscopy. Results revealed that exposing the material to a temperature of 525 °C (optimal temperature of superplastic deformation for this alloy) led to agglomeration of single vacancies into vacancy clusters of size of approximately four vacancies. Evidence for superplastic strain-induced cavitation was not found at 450 °C up to an elongation of 432% and at 525 °C up to 341%, the initial strain rate of deformation in both cases being 1.0 ×10−3 s−1. These results have practical significance.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable