Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T15:41:36.515Z Has data issue: false hasContentIssue false

Transformation-induced plasticity in Fe–Cr–V–C

Published online by Cambridge University Press:  31 January 2011

Horst Wendrock
Affiliation:
IFW Dresden, Institute for Complex Materials, D-01171 Dresden, Germany
Jürgen Eckert*
Affiliation:
IFW Dresden, Institute for Complex Materials, D-01171 Dresden, Germany; and Technical University (TU) Dresden, Institute of Materials Science, D-01062 Dresden, Germany
*
b)This author was an editor of this journal during the review and decision stage. For the JMR policy on review and publication of manuscripts authored by editors, please refer to http://www.mrs.org/jmr_policy
Get access

Abstract

On the basis of the Fe84.3C4.6Cr4.3Mo4.6V2.2 high-speed tool steel, manufactured under relatively high cooling rates and highly pure conditions, a further improvement of the mechanical characteristics by slight modification of the alloy composition was attempted. For this, the alloy Fe88.9Cr4.3V2.2C4.6 was generated by elimination of Mo. By applying special preparation conditions, a microstructure composed of martensite, retained austenite, and a fine network of special carbides was obtained already in the as-cast state. This material exhibits extremely high compression strength of over 5000 MPa combined with large compression strain of more than 25% due to deformation-induced martensite formation. With this alloy a new composition of transformation-induced plasticity-assisted steels was found, which shows an extreme mechanical loading capacity.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable