Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T06:36:12.604Z Has data issue: false hasContentIssue false

Void Nucleation in Passivated Interconnect Lines: Effects of Site Geometries, Interfaces, and Interface Flaws

Published online by Cambridge University Press:  31 January 2011

R. J. Gleixner
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, California 94305-2205
B. M. Clemens
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, California 94305-2205
W. D. Nix
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, California 94305-2205
Get access

Abstract

Stress driven nucleation of voids in passivated aluminum interconnect lines is analyzed within the context of classical nucleation theory. A discussion of sources of tensile stress in such lines leads to an upper limit of 2 GPa. Calculations suggest that even at this high stress, nucleation rates are far too low to account for observed rates of voiding. Void formation at a circular defect at the line/passivation interface is then considered. In this case, a flaw on the order of nanometers in size may develop into a void under the imposed stress. These results strongly suggest that void nucleation in aluminum interconnect lines can be controlled by eliminating defects in the line/passivation interface.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable