Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T10:08:03.278Z Has data issue: false hasContentIssue false

Injection Molding Simulation of 3D Stacked-Chip Assembly Packaging with Different Entrances

Published online by Cambridge University Press:  05 May 2011

C.-M. Lin*
Affiliation:
Department of Mechanical Engineering, WuFeng Institute of Technology, Chia-Yi, Taiwan 62153, R.O.C.
T.-C. Lin*
Affiliation:
Department of Computer Science and Information Engineering, WuFeng Institute of Technology, Chia-Yi, Taiwan 62153, R.O.C.
H.-M. Chu*
Affiliation:
Department of Mechanical Engineering, Yung-Ta Institute of Technology and Commerce, Ping-Tung, Taiwan 90942, R.O.C.
Y.-L. Chen*
Affiliation:
Department of Fire Science, WuFeng Institute of Technology, Chia-Yi, Taiwan 62153, R.O.C.
*
*Associate Professor
**Assistant Professor
**Assistant Professor
*Associate Professor
Get access

Abstract

This paper adopts a three-dimensional (3D) finite element method to simulate the injection molding of organic 3D stacked-chip assemblies. The geometry model of the assembly is simplified to a five-layered structure of stacked-chips with no solder bumps. The injection molding process incorporates 3D stacked-chip packaging and encapsulation techniques, and comprises primarily of multi-layer cavity-filling and reactive-thermosetting curing processes. The current investigation considers the effects of specifying different entrances on the resultant flow fronts, air-traps, and weld-lines. In general, the present results confirm the value of performing numerical simulations of the 3D stacked-chip packaging process to support the injection molding CAE approaches which are commonly applied nowadays to improve the packaging assembly design and to facilitate the rapid set up of mass-production conditions. The simulation results indicate that the best packaging results are obtained when the melt is introduced either at the center of the periphery side of the stacked-chip modulus or at its corner.

Information

Type
Articles
Copyright
Copyright © The Society of Theoretical and Applied Mechanics, R.O.C. 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable