Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T11:06:40.925Z Has data issue: false hasContentIssue false

Micro-System Displacement and Profile Measurement By an Integrated Photon Tunneling and Confocal Microscope

Published online by Cambridge University Press:  05 May 2011

Wen-Jong Chen*
Affiliation:
Institute of Mechanical Engineering, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Chih-Kung Lee*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Shui-Shong Lu*
Affiliation:
Institute of Mechanical Engineering, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Long-Sun Huang*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Ta-Shun Chu*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Ying-Chou Cheng*
Affiliation:
Institute of Mechanical Engineering, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Wu-Fone Yeh*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
*
*Ph.D. student
**Professor
**Professor
***Assistant Professor
****Graduate student
*Ph.D. student
****Graduate student
Get access

Abstract

An integrated optical method for measuring deformation of micro-mechanical systems with better than sub-micron resolutions is detailed. Both a confocal laser scanning microscope and a photon tunneling microscope were integrated into a single microscopy system due to their complimentary capabilities for examining sub-micrometer deformations. A halogen lamp and laser were adopted as the two light sources for the measurements. Since topographic information of samples up to a 15μm by 15μm area can be measured, a three-dimensional displacement field of the sample was extracted by comparing topographies of the same specimen area before and after deformation. The bending and twisting deformation of a micro-mirror driven by the electrostatic force was measured to demonstrate the capability of this newly developed instrument. The experimental data obtained agrees reasonably well with the theoretical results calculated by adopting an analytical solution and a finite element method. The small discrepancy in the result can be traced to the surface roughness effect, which is often non-negligible in micro-systems.

Information

Type
Articles
Copyright
Copyright © The Society of Theoretical and Applied Mechanics, R.O.C. 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable