Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T02:22:37.025Z Has data issue: false hasContentIssue false

On Navigation Systems for Motorcycles: The Influence and Estimation of Roll Angle

Published online by Cambridge University Press:  19 August 2005

Joshua P. Coaplen
Affiliation:
Department of Mechanical Engineering, University of California. Email: oreilly@berkeley.edu
Patrick Kessler
Affiliation:
Department of Mechanical Engineering, University of California. Email: oreilly@berkeley.edu
Oliver M. O'Reilly
Affiliation:
Department of Mechanical Engineering, University of California. Email: oreilly@berkeley.edu
Dan M. Stevens
Affiliation:
Department of Mechanical Engineering, University of California. Email: oreilly@berkeley.edu
J. Karl Hedrick
Affiliation:
Department of Mechanical Engineering, University of California. Email: oreilly@berkeley.edu
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Vehicle navigation systems use various sensors and the global positioning system (GPS) to locate a vehicle. This location is then matched to a map database to provide navigation information. Between GPS updates, the vehicle's heading angle and forward speed are used to “dead reckon” its position. Heading angle is often measured by integrating the output of a rate gyroscope. For this measurement to be equal to the vehicle's heading angle, the vehicle should not experience any rotation about its roll or pitch axes. For an automobile, the roll and pitch angles are small and may be neglected for the purposes of navigation. This article demonstrates that this same assumption is not true for a motorcycle. Through simulation, it is shown that for a motorcycle, obtaining a meaningful heading angle from a single angular rate measurement requires accounting for the motorcycle's roll angle. Methods to estimate roll angle and heading angle from available navigation measurements are presented, and two possible sensor configurations are compared. A motorcycle navigation scheme based on these roll angle estimation methods is shown to produce exceptional results in a simulation environment.

Information

Type
Research Article
Copyright
© 2005 The Royal Institute of Navigation