Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T13:51:54.058Z Has data issue: false hasContentIssue false

Analcime reactions at 25–90°C in hyperalkaline fluids

Published online by Cambridge University Press:  05 July 2018

D. Savage*
Affiliation:
Quintessa Ltd, 24 Trevor Road, West Bridgford, Nottingham NG2 6FS, UK
C. Rochelle
Affiliation:
British Geological Survey, Keyworth, Nottinghamshire NG12 5GG, UK
Y. Moore
Affiliation:
British Geological Survey, Keyworth, Nottinghamshire NG12 5GG, UK
A. Milodowski
Affiliation:
British Geological Survey, Keyworth, Nottinghamshire NG12 5GG, UK
K. Bateman
Affiliation:
British Geological Survey, Keyworth, Nottinghamshire NG12 5GG, UK
D. Bailey
Affiliation:
British Geological Survey, Keyworth, Nottinghamshire NG12 5GG, UK
M. Mihara
Affiliation:
Japan Nuclear Cycle Development Institute (JNC), Waste Isolation Research Division, Waste Management and Fuel Cycle Research Center, Tokai Works, Muramatsu, Tokai-Mura, Naka-gun, Ibaraki 319-1194, Japan

Abstract

Extensive use of cement and concrete is envisaged in the construction of geological disposal facilities for radioactive wastes. The hyperalkaline porefluids typical of groundwaters that have reacted with these materials have the potential to react chemically with other engineered barrier components such as bentonite, potentially degrading their performance. Analcime, NaAlSi2O6.H2O, has been identified from previous modelling and experimental studies as a potential alteration product of bentonite.

Laboratory experiments to investigate the stability of analcime under hyperalkaline porefluid conditions have been performed. Experiments used both batch and fluidized bed equipment at 25, 50, 70 and 90°C in K-based pH buffer solutions, both under- and over-saturated with respect to analcime. Results from dissolution experiments demonstrate that release of Na was greatly enhanced (by up to a factor of thirty) over that for Si and Al, particularly at pH 10 and 11. However, enhanced release of both Na and Al occurred in the batch experiments at pH 12–13. Near stoichiometric dissolution was observed in fluidized bed experiments under steady-state conditions at 70°C. Sodium was removed from the analcime structure by ion exchange for K, without involving dissolution and re-precipitation of the analcime framework. Scanning electron microscopy of reacted analcime grains showed that some grains had pronounced cracks parallel to original cleavage traces. These cracks were a result of volume decrease due to the substitution of K for Na ions and water molecules in the analcime structure to form leucite, KAlSi2O6.

Synthesis of the dissolution data shows that the rate of dissolution increased with increasing temperature in the range 25–70°C and with pH at each temperature. Absolute rates of dissolution ranged from 10−10 mol m−2 s−1 at pH 9.5 at 25°C to 10−7 mol m−2 s−1 a pH 12 at 70 and 90°C. The rate of dissolution at any temperature was pH-dependent, such that the rate could be described by k (a H+)n , where k is the rate constant and n is −0.3 at 25°C, −0.4 at 50°C, −0.6 at 70°C and −0.7 at 90°C. Attempts to measure the growth rate of analcime in supersaturated solutions at 70 and 90°C were unsuccessful, although a limiting rate at 70°C, pH 10 was calculated to be 4 × 10−11 mol m−2 s−1, roughly 100× less than the rate of dissolution under the same conditions.

These results imply that any trace amounts of analcime in bentonite will be converted to leucite by reaction with cement fluids with a high K/Na ratio. In some instances, leucite may thus incorporate K+ in preference to other phases (e.g. illite, K-feldspar) during alteration of bentonite by cement porefluids.

Information

Type
Research Article
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable