Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T05:56:11.033Z Has data issue: false hasContentIssue false

Forsterite dissolution in superheated basaltic, andesitic and rhyolitic melts

Published online by Cambridge University Press:  05 July 2018

C. H. Donaldson*
Affiliation:
Department of Geology, University of St Andrews, Fife, KY16 ST, Scotland

Abstract

Dissolution rates of small forsterite spheres in superheated melts of basalt, andesite and rhyolite composition have been measured at 1300°C, atmospheric pressure. The rate is constant (83 µm hr−1) in the basalt, regardless of run duration. In the andesite the initial dissolution rate is 200µm hr−1, followed by a decrease to a constant value of 16µmhr−1 in 2–3 hours. Dissolution rate in the rhyolite decreases from an initial value of 1.7 to <0.1 µmhr−1 over 280 hours and never reaches a constant rate. Once the rate of dissolution has become constant, the film of contaminated melt that forms in melt about a crystal does not thicken with time, indicating attainment of a steady-state condition. Steady state is attributed to natural convection arising from the difference in density between the film of contaminated melt surrounding a crystal and that beyond. The density difference is approximately 2% of the density of the rock melt.

Information

Type
Geochemistry and Petrology
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable